Certainteed Bailey Manual do Utilizador descarregar pdf

EASY TO INSTALL

OUTSIDE CORNERS Apply a band of joint

compound 100mm (4”) wide and 6mm (1/4”) thick

to each side of the corner.

Cut corner bead to length required and position

over the joint compound allow 1/2” at bottom for

expansion and contraction of framing members.

Embed the corner bead firmly into the compound.

Using a small finishing knife, wipe the excess

compound from under the paper to eliminate all air

bubbles. Allow to dry. (Be careful not to remove

all compound)

Using a large finishing knife, apply compound

in a band about 200mm (8”) wide from the

nose of the bead beyond the paper edge.

Level compound by drawing the knife along the

bead with one edge of the blade riding on the

nose of the bead and the other on the surface

of the board. Repeat for the other side of

corner bead. Allow to dry.

Apply second coat once previous coat is dry.

Feather the edges of each coat about 50mm (2”)

beyond the preceding coat.

INSIDE CORNERS Inside corners are installed similarly to outside corners except usually only one cover

coat is required. An inside corner tool can be used to apply and smooth the compound if desired.

L-TRIM L-Trim is installed similar to outside corners except only one side is finished.

BULLNOSE CORNERS Bullnose corners are installed similar to square corners with exception to the

drywall edges not to exceed the corner of the framing substraight.

EASY TO INSTALLOUTSIDE CORNERS Apply a band of jointcompound 100mm (4”) wide and 6mm (1/4”) thickto each side of the corner.Cut corner bead to length

Sem comentários

Certainteed Bailey Manual do Utilizador